User's Manual

2) Control module selection for scantool and fault code searching
(1) Selection of control module for scantool
By selecting “Vehicle”, “Model Year”, and “Engine” in the “Vehicle Selection”, VCI module for
vehicle communication is selected in the “Selected section” in default, for using “Scantool” function.
Default setting for “Selected” section is always in “Engine”, and user can change to other control
modules. [Figure 5] below shows the state that is set in default as an “Engine”, and [Figure 6]
shows the state that is changed into “ANTILOCK BRAKE SYSTEM”.
[Figure 5. “ENGINE” selection in “Selected” section]
[Figure 6. “ABS” selection in “Selected” section]
User’s Manual
Module : A-04-006 (p.04)