User's Manual

[Figure 8. Control module change]
③ Change of control module for scantool function
Among the control modules in the “Selected” section, it is possible to assign a control module
as a default setting for the communication during the use of “ScanTool” function. The Icon with
the “V” sign on the top, is a default module that will be used for communication. Change in the
default communication module is made through the mouse selection of other control modules.
The “V” sign will appear on the top of the selected module icon.
[Figure 9. Change of control module for scantool function]
User’s Manual
Module : A-04-006 (p.06)