User's Manual

(3) Process and result for fault code searching function
By Setting and running “ Fault Code Searching” function in the “ Vehicle Selection” can
automatically diagnose DTC during the use of other Hi-Diagnosis functions through the
communication between a VCI and a vehicle.
The progress rate for the Fault Code Searching will be displayed on the top of the “Fault Code
Searching” icon, which is located on the lower section of the Hi-Diagnosis screen.
It will be displayed as shown in [Figure 10-1] when there is a communication with the assigned
module. When there is a DTC in any of the module, the icon will be displayed as shown in [Figure
10-2]. DTC list can be checked by clicking the icon in the state of [Figure 10-2].
[Figure 10. Process and result for fault code searching]
[Figure 10-1] [Figure 10-2] [Figure 10-3]
User’s Manual
Module : A-04-006 (p.07)