Users Manual

Operating Manual Smart Weather Sensor
G. Lufft Mess- und Regeltechnik GmbH, Fellbach, Germany 33
9 Commissioning
After the equipment has been installed and connected correctly, the sensor begins
autonomously to take measurements. A Windows
®
PC with serial interface, ConfigTool.NET
software and interface cable (SUB-D 9 pole; jack - socket; 1:1) are required for configuration
and test purposes.
Attention must be paid to the following points:
Check for correct equipment operation on site by carrying out a measurement request with
the aid of ConfigTool.NET (see page 44).
• Configure the local altitude in order to ensure the correct calculation of relative air
pressure (see page 37).
• The device must be aligned to the North in order to ensure correct wind measurement
(see page 27), or the automatic compass correction must be activated (see page 37).
• In order to get correct compass headings the local declination must be configured (see
page 20and 37).
• If several Smart Weather Sensors are operated on a UMB network, a unique device ID
must be assigned to each device (see page 36).
There is no protective cover to remove on the sensor itself.