Users Manual

DSS (DUAL SPEAKER STEREO)
With DSS, you can connect two G-BOOM3s together to stream in stereo to both at
the same time to enjoy music with double the power and expanded stereo separation.
1 Power on two G-BOOM3 speakers and switch both to Bluetooth mode.
2 Follow directions to pair and connect a Bluetooth device to one G-BOOM3 (master)
3 Press DSS button on the master G-BOOM3 speaker which is already connected
Bluetooth device to enter DSS mode, the LED ring will ash amber.
4 Press DSS button on the other G-BOOM3 speaker to enter DSS mode, the LED
ring will ash amber indicating. When the two speakers are connected, the amber
LED ring will change from ashing to solid.
5 To disconnect the DSS, press the BLUETOOTH PAIR button on one G-BOOM3.
6 Repeat the above steps to re-connect the two G-BOOM3.
NOTES:
- DSS mode require two G-BOOM3 speakers.
- You need to connect a Bluetooth device to the master speaker before you enter DSS mode.
- After connected the two speakers, the volume level in these two speakers will be synchronized.
and the EQ can be individually set for each speaker.
- If you cannot connect two speakers successfully, press and hold the DSS button for 3 seconds on
both G-BOOM3 to reset memory and then repeat the above steps to connect two speakers again.
- Only Bluetooth can work with DSS. Radio and LINE-IN does not work with DSS.