Operation Guide
Table Of Contents
- Before Getting Started...
- Time Adjustment
- Using Mobile Link with a Mobile Phone
- Getting Ready
- Auto Time Adjustment
- Mode Customization
- Customizing the Timekeeping Mode Screen
- Viewing Step Count Data
- Recording Your Current Location (Location Memory)
- Checking the Distance and Bearing to a Location Memory Point (Location Indicator)
- Auto Altitude Calibration
- Recording Waypoints and Their Altitudes (Mission Log)
- Configuring World Time Settings
- Adjusting Hand Alignment
- Phone Finder
- Configuring Watch Settings
- Changing the Home City Summer Time Setting
- Connection
- Digital Compass
- Altitude Measurement
- Barometric Pressure Measurement
- Checking the Current Barometric Pressure
- Checking Changes in Barometric Pressure Over Time
- Checking the Change in Barometric Pressure between Two Readings
- Barometric Pressure Change Indications
- Calibrating Barometric Pressure Readings (Offset)
- Specifying the Barometric Pressure Unit
- Barometric Pressure Reading Precautions
- Temperature Measurement
- Viewing Altitude Records
- Sunrise and Sunset Times
- Stopwatch
- Timer
- Alarms and Hourly Time Signal
- World Time
- Pedometer
- Hand Alignment Adjustment
- Other Settings
- International Travel
- Other Information
- Troubleshooting
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Use the operations below to perform a
timer operation.
A
A
A
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (C).
3. Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The beeper will not sound if battery power
is low.
Configuring Alarm Settings
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (A) and (C) to display the number
([AL1] to [AL5]) of the alarm whose
settings you want to change.
Alarm number
Alarm time
3. Hold down (D) for at least two seconds.
Release the button when the hour digits
start to flash.
●
The (alarm) indicator is displayed
when any alarm is turned on.
Hours
4. Use (A) and (C) to change the hour setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (E).
This causes the minutes digits to flash.
Minutes
6. Use (A) and (C) to change the minute
setting.
7. Press (D) to exit the setting screen.
8. Hold down (E) for at least two seconds to
return to the Timekeeping Mode.
● To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper sounds for 10 seconds when
an alarm time is reached.
●
You can also use G-SHOCK
Connected to configure alarm time
settings.
Configuring the Hourly Time
Signal Setting
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (A) or (C) to display the hourly time
signal screen ([SIG]).
3. Press (D) to toggle the hourly time signal
between enabled (on) and disabled (off).
●
(hourly time signal) is shown on the
display while the hourly time signal is
enabled.
Note
●
You can also use G-SHOCK
Connected to configure the hourly time
signal setting.
Operation Guide 5594
29