User Manual

ELECTRICAL SPECIFICATIONS
:
Frequency Range
Downlink : 880-894 MHz
Uplink : 835-849 MHz
Pass Band Gain @ min attenuation : 80 dB (min.)
Variable Step Attenuator Range : 0-30 dB
(2-dB steps)
Pass band Ripple : ±1.5 dB (typ)
Noise Figure @+25
°C at max gain : 4.0 dB max.
3rd Order Intercept point
Uplink : +48 dBm (typ)
Downlink : +48 dBm (typ)
*Output Power @ 1dB Compression
Uplink :+36dBm (typ)
Downlink :+36dBm (typ)
*ALC Factory Set Point
Uplink : +26 dBm
Downlink : +26 dBm
Isolation between Up/Down Link : 100 dB min.
Input/ Output Impedance : 50 Ohms
VSWR (Input/Output) : 1.5: 1 max.
Power Supply : 110VAC/0.89 Amp
: 240VAC/0.45 Amp
: 50 to 60 Hz
*The Manufacturer's rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5
dB, especially where the output signal is re-radiated and can cause interference to adjacent band
users. This power reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device.
Page 5