User Manual

Page | 7
MECHANICAL SPECIFICATIONS:
Size : 16.0 x 16.0 x 11.2 inch
(406 x 406 x 284.5 mm)
Weight : 35 Lbs. (16.0kg.) approx.
ENVIRONMENTAL CONDITIONS:
The unit is designed for outdoor applications:
Operating temperature: -45ºC to +60ºC
Storage temperature: -50ºC to +90ºC
FCC NOTE:
The Federal Communications Commission (FCC) has tested this product and found it to
comply with their RF Exposure Requirements, pursuant to FCC Part 22 and 24.
IC NOTE:
The Industry Canada (IC) has tested this product and found it to comply with their RF
Exposure Requirements, pursuant to
IC RSS-131.
NOTE:
The Manufacturer’s rated output power of this equipment is for single carrier
operation. For situations when multiple carrier signals are present, the rating would
have to be reduced by 3.5 dB, especially where the output signal is re-radiated and
can cause interference to adjacent band users. This power reduction is to be by
means of input power or gain reduction and not by an attenuator at the output of the
device.
RF EXPOSURE WARNING
In order to comply with the FCC RF exposure requirements, the BDA-CELLAB/PCSF-
2/2W-80-OCA1 antenna installation must comply with the following:
Yagi type or similar directional antenna must be installed so as to provide a minimum
separation distance of 30cm (~12 inches) between the antenna and persons within the
area. (This assumes an antenna with gain of 11 dBi, VSWR ≤ 1.5:1, Zo= 50 ohms)
The Omni directional (or leaky cable ) must be installed so as to provide a minimum
separation distance of at least 20cm (~7.9 inches) between the indoor antenna
connected to the RF booster and the human user’s body within the area. (This
assumes an antenna with gain of 0-2 dBi, VSWR ≤ 2:1, Zo= 50 ohms).