User's Manual

PID2_UserManual.doc 13
 Do not install the PHMU on or within 4 feet of any large metallic/reflective objects, devices
or appliances such as mirrors, TVs, stereo systems, video/gaming systems, computers,
refrigerators, microwaves or washers and dryers.
 Do not install the PHMU in front of a window or in direct sunlight.
 Avoid installing the PHMU on an outside wall of a home.
PID Preparation
PATROL SUITE RF has a PID that must be installed on the participant to monitor their activity with
continuous signaling Radio Frequency (RF). To prepare the PID Band for installation, refer to the
procedures/figures below:
1. Slide the Alignment Tool along the PID Band until the line on the tool coincides with the first cut-
line on the PID Band.
The four posts on the tool should also align with the four holes in the PID Band.
2. Press the PID Band down on these posts to secure it to the Alignment Tool.
3. Place the Cutting Tool in the slot on the Alignment Tool and press down firmly to cut the PID
Band.
Figure 14: PID Band, Cutting and Alignment Tool
4. Insert the cut end of the PID band into one end of the PID housing.
5. Secure the PID Band in place by inserting the PID Retaining Pin into the PID housing, making
sure the opening on top of the PID Retaining Pin is facing the body of the PID. The insertion
piece of the PID Retaining Pin can now be removed.
NOTE: Proper
orientation when
inserting the
Retaining Pin is
necessary to
secure the Sleeve.
Figure 15: Inserting Retaining Pin Figure 16: Proper Orientation of Retaining Pin