User's Manual

PID2_UserManual.doc 16
PHMU. The enrollment process can be completed without a phone line connection. If unsure of
the type of phone system or voltage, inquire with your telecom coordinator or have the voltage
level measured prior to connecting the phone line to the PHMU.
4. Plug the PHMU Power Adaptor into both the outlet and the PHMU. The LCD screen will illuminate
and display the PHMU Serial Number and Setup Menu while the green LED confirms a power
connection.
Installation Process
1. Select ENRL from the Setup Menu
If installing a Cellular PHMU, select GSM
from the Enroll Menu to determine the
cellular signal strength and ideal placement
of the PHMU.
2. The PHMU will find any active PIDs within range
and display their serial numbers on the LCD
screen. Enroll the appropriate serial number by
selecting ACEPT. To bypass other serial
numbers, select IGNR.
3. Once the correct serial number is accepted,
place the second sleeve over the PID Band and
install the PID on the participant by inserting the
PID Band into the other end of the PID housing,
inserting the PID Retaining Pin and securing the
PID Sleeve over the PID Retaining Pin.
NOTE: The PID LED will to blink for
approximately thirty seconds after band closure.
It will then emit a series of short blinks and the
LCD screen will display ‘Band Close Confirmed’.
4. The PHMU will initiate the enrollment call and the
LCD screen will display a series of status
messages.
a. If the enrollment call is successful, select
OK to acknowledge and return to the Setup Menu.
b. If unsuccessful, select RETRY or < to exit and return to the Setup Menu.
5. If no other programming is required, turn the PHMU Menu Key to the vertical position and
remove from the PHMU. Installation is complete.
Office vs. Residential Installation Procedures
1. If this installation took place in the participant’s residence, please proceed with the Range Test.
2. If this installation took place in the office or a location away from the participant’s residence: