User's Guide

 26
Initialising an MU
1. Phone the monitoring centre and give them
the MU and PID/SOLO’s serial numbers.
2. Multicom/Landline MU ONLY—Connect an ordinary
phone to the phone line and check that the line is active.
DO NOT connect the MU to the phone line at this stage.
3. Place the MU in a suitable location and plug it into the mains
power supply. (See
MU/TU-Dock Positioning Tips on page
25).
Multicom/GSM MU ONLY—The MU will automatically
start to initialise and register with the GSM mobile
network.
If the MU displays “NO GSM SIGNAL”,
move the MU to a different location.
4. While the MU is initialising, measure the subject’s ankle and
select the correct size of strap. (See
Preparing Straps for
Installation
on page 29).
5. Next, t either a PID or a SOLO tag to the subject.
(See
Fitting a PID to a Subject on page 30,
or Fitting a SOLO to a Subject on page 33).
Initialising Monitoring Unit
. . . . . . . . . . . .