User's Guide

 30
Before tting a PID to a subject, select and prepare the correct
size strap. (See Preparing Straps for Installation on page 29).
Make sure that the MU or TU is initialised. (See
Initialising an
MU
on page 26, or Initialising a TU on page 27).
1. With the Strap Fitting Lever closed, click the PID into the
tool. (Figure 1)
2. Push one end of the strap between the tool’s jaws.
3. Pull on the free end of the strap so that the clip is tight
against the jaws. (Figure 2)
4. Open the Strap Fitting Lever, until you hear a click.
(Figure 3)
The strap is now tted in one end of the PID.
Continued on next page.
Fitting a PID to a Subject
Figure 1
Click PID into Tool
Figure 2
Pull on free end of strap
Figure 3
Open the strap-tting-lever