User's Guide

PID SLEEP
/ FAULT
PID
OK
 31
Fitting a PID to a Subject (continued)
5. Check that the PID SLEEP/FAULT light is ashing red.
6. Close the Strap Fitting Lever and remove the PID and strap
from the tool. (Figure 4)
7. Pull the end of the strap to make sure that it is securely
tted into the PID.
8. Push the free end of the strap between the tool’s jaws.
9. Pull on the strap so that the clip is tight against the jaws.
(Figure 5)
Continued on
next page.
Figure 5
Pull on free end of strap
Figure 4—Remove PID and strap from tool