User's Guide

PID SLEEP
/ FAULT
PID
OK
 32
10. Holding the tool, wrap the strap and PID around the
subject’s ankle and click the PID into the Installation Tool.
(Figure 6)
11. Open the Strap Fitting Lever, until you hear a click.
The strap should be tted securely
around the subject’s ankle.
12. Check that the PID OK light is ashing green.
13. Close the Strap Fitting Lever and remove the tool from
the PID. (Figure 7)
14. Pull on the ends of the strap to make sure that it is securely
tted into the PID.
15. Next, perform a Range Survey.
(See
MU Range Survey and Data Upload on page 37,
or TU Range Survey and Data Upload on page 39).
Fitting a PID to a Subject (continued)
Figure 6
Wrap strap
around
subject’s
ankle
Figure 7
Remove the
tool from the
PID