User's Guide

 33
Fitting a SOLO to a Subject
Before tting a SOLO to a subject, select and prepare the correct
size strap. (See Preparing Straps for Installation on page 29).
SOLO tags can be either installed on their own, or with an MU. If
you are installing a SOLO with an MU, make sure that the MU has
been initialised. (See
Initialising an MU on page 26).
1. Phone the Monitoring Centre and
give them the SOLO’s serial number.
2. With the strap-tting-lever closed,
click the SOLO into the tool. (Figure 1)
3. Push one end of the strap
between the tool’s jaws.
4. Pull on the free end of the strap so that the
clip is tight against the tool’s jaws. (Figure 2)
Figure 1
Click SOLO
into Tool
Figure 2
Pull on free
end of strap
Continued on next page.