User's Guide

PID SLEEP
/ FAULT
PID
OK
 42
To abandon an install at any point:
1. Remove the Tag
 Cut the middle of the strap with scissors and remove
the PID or SOLO from the subject. (Figure 1)
!
Note: It is impossible to switch the tag to sleep
mode, unless the strap has been cut or opened.
2. Switch Off the Tag
 Clip the tool over the PID/SOLO.
 Press the PID ON/OFF button.
The PID SLEEP/FAULT light on the side of the tool
shines amber to show that the tag is in sleep mode,
then starts ashing red to indicate a strap-cut tamper.
(See
PID Status Lights on page 20).
3. Reset the MU or TU
 Press the red button on the MU.
Or:
 Press the right-hand button on the TU.
Abandoning an Install
ON /
OFF
Figure 1
Cut middle
of strap with
scissors