User's Guide

PID SLEEP
/ FAULT
PID
OK
 43
Follow the steps below to remove a tag at the end of a curfew period:
1. Switch Off the MU or TU
 Unplug the MU or docking station from the mains power supply.
 Point the tool at the front of the MU or the bottom of the TU.
(See Linking to MUs on page 14, or Linking to TUs on page 15).
 Press the MU OFF button.
2. Remove the Tag
 Cut the middle of the strap with scissors and remove
the PID or SOLO from the subject. (Figure 1)
!
Note: It is impossible to switch the tag to sleep
mode, unless the strap has been cut or opened.
3. Switch Off the Tag
 Clip the tool over the PID or SOLO.
 Press the PID ON/OFF button.
The PID SLEEP/FAULT light on the side of the tool
shines amber to show that the tag is in sleep mode,
then starts ashing red to indicate a strap-cut tamper.
(See
PID Status Lights on page 20).
Removing a Tag
MU
OFF
ON /
OFF
Figure 1
Cut middle
of strap with
scissors