User's Guide

 44
Follow the steps below to replace a tampered or faulty PID:
1. Switch off the MU or TU. (See
Removing a Tag on page 43).
2. Cut the middle of the strap with scissors
and remove the tag from the subject. (Figure 1)
3. Put the PID into sleep mode. (Clip the tool over the tag
and press the PID ON/OFF button).
4. Phone the monitoring centre and tell
them the new tag’s serial number.
5. Plug the MU or docking station back into the mains power
supply.
6. Fit the new tag to the subject. (See
Fitting a PID to a Subject
on page 30, or Fitting a SOLO to a Subject on page 33).
7. Continue with the rest of the install procedure. (See
MU
Range Survey and Data Upload
on page 37, or TU Range
Survey and Data Upload
on page 39).
Replacing a Tag
ON /
OFF
Figure 1
Cut middle
of strap with
scissors