User's Guide

PID
GET
STATUS
ON /
OFF
 47
RAM (Random Alternative Monitoring) mode allows you to nd
out if there are any PIDs or SOLOs nearby. You can perform a
RAM using the tool on its own to quickly detect any tags and get
their tamper status.
Use the EMMO software running on a PDA to get the full details
of any detected tags (See the EMMO User Guide).
To Put the Tool into RAM Mode:
1. Press and hold down the
PID GET STATUS
button for 3 seconds.
2. While still holding down the
PID GET STATUS button,
press the PID ON/OFF button.
Performing a RAM Survey
The RAM light blinks every time a tag’s radio signal is
detected. The colour of the blink shows the status of each
detected tag:
RAM Light Meaning
Green Flash Active tag found, no tamper.
Red Flash Tampered tag found.
Amber Flash Tag with low battery found.
Each active tag transmits a radio signal every 10 seconds.
For example, if the tool detects only one tag, the RAM
light blinks once every 10 seconds. If there are two tags
nearby, the RAM light blinks twice every 10 seconds etc.
OK
MU
FAULT
EMMO RAM