User's Manual

Table Of Contents

Mount the Reader

Installation and User Instructions for S680 & S690 Readers

You can remove the front cover by

easing it off gently with a screwdriver

at this point

Reader Connections

Note: (For UL Listed Products)

1). Consult local AHJ (Authority Having Jurisdiction) when installing access control readers and locking

mechanisms to any portal in an egress path.

2). The use of Fail Closed / secure configuration shall be determined by local building codes and the

local AHJ.

3). Wiring methods shall be in accordance with NEC (National Electrical Code) ANSI/NFPA 70.

4). All Interconnected devices must be UL listed.

5). For UL294 Installations the S680 and S690 Readers have only been determined compatible to be

used with the M2150 Series Control and Elevator Units.

You should find that the

backplate has holes for

connection to most standard

electrical back boxes.

The S680 and S690 readers are

readers that are capable of reading HID format card,

with LED’s. The readers use

For additional information regarding the installation,

configuration and proper use of this product please

refer to:

M2150 Design Guide, P/N 9600-0420 Issue 1.6.4 or

later and SMS Software User Guide, P/N 9600-0429

Issue 7.0.4 or later.

125kHz proximity card

20mA current loop

communications.

Mount the backplate using

countersunk headed screws

adjacent to the opening edge

of the door.

PAGE 1
Installation and User Instructions for S680 & S690 Readers The S680 and S690 readers are 125kHz proximity card ® readers that are capable of reading HID format card, with LED’s. The readers use 20mA current loop communications. For additional information regarding the installation, configuration and proper use of this product please refer to: M2150 Design Guide, P/N 9600-0420 Issue 1.6.4 or later and SMS Software User Guide, P/N 9600-0429 Issue 7.0.4 or later.
PAGE 2
3 Reader Connections contd. 20mA current loop Shielded Belden 9537 7x24 awg cable UL Listed style 2464 (DUZX) cable. Controller 12V Red 12V 0V Black 0V RX- Green TX+ Orange TX- TX+ White RX+ TX- Blue RX- RX+ Maximum distance 150m Connect shield at controller end only. 4 680/690 Reader Note: Brown wire not used Using / Testing the Reader Present the card face-on to the reader until you hear a "bleep". The reader is now working correctly.