User's Manual

ManualsBrandsG4S Technology ManualsElectronicsRFID Tag Reader

Installation and User Instructions for S853 Readers

You should find that the

backplate has holes for

connection to most

standard electrical

backboxes.

With the backplate off (see above), mount

the backplate adjacent to the opening edge

of the door and at a convenient height. Feed

the required cables through the backplate:

The cable from the controller.

The cable from the heater, if used (must

be a separate cable).

A cable from a Remote Interface Module

(RIM), if used. A RIM can reduce cable

lengths to door furniture.

The optional heater kit maintains the reader at

the correct temperature when mounted outside.

With the backplate off, remove the backing paper

from the two elements, then stick them to the

inner sides of the reader. The heaters must be

connected to a 24V AC supply (min 25VA).

When mounting outside, the two-part gasket kit

must be fitted:

a) Remove the backplate from the reader by

releasing the two securing screws.

b) Remove the cutouts and backing paper

from the two gaskets, then stick them to the

backplate as shown.

Outer gasket

Inner

gasket

Backplate

securing screws

Backplate

Fit the Weatherproofing Kit

Mount the Backplate

Ensure no jumpers are fitted across LK2 (TEST) and LK3 (NODE TERM) and LK4 (HGU TERM). If a

jumper is provided, park it across one pin only. LK1 (USER FB) - set to 1 for sound on and 0 for sound off.

Reader Links

The S853 is a combined contact and contactless smart-

card reader, with LCD and keypad, which uses

p . The S853 is

able to read Philips MIFARE and Philips MIFARE DESfire

smart cards.

For either type of card, the S853 supports the use of

unencoded cards (where only the unique card serial

number is read), or cards encoded with a card number.

Several encoding formats are supported.

The reader can simultaneously support two different card

types/formats (e.g. non-encoded MIFARE and smartMAX-

encoded MIFARE DESfire, or non-encoded MIFARE and

smartMAX-encoded MIFARE). The reader is automatically

configured to accept the first two contactless and the first

contact card types/formats presented.

20mA

current loop seudo-random communications

®®

Summary of content (2 pages)

PAGE 1
Installation and User Instructions for S853 Readers The S853 is a combined contact and contactless smartcard reader, with LCD and keypad, which uses 20mA current loop pseudo-random communications. The S853 is ® ® able to read Philips MIFARE and Philips MIFARE DESfire smart cards. For either type of card, the S853 supports the use of unencoded cards (where only the unique card serial number is read), or cards encoded with a card number. Several encoding formats are supported.
PAGE 2
4 Reader Connections Reader 12V Controller connections (20mA current loop) +V 0V TX- RXRX+ I/0 TXTX+ Do not use TX+ RXRX+ Connect shield at controller end only (attach to case). 5 The I/O terminal is for connection to a RIM (see the RIM Instructions). On completion, re-secure the reader to the backplate. Twisted pairs (use Belden 9503 cable) 0V Reader Configuration The reader supports the first two contactless and the first contact card types/formats presented after power-up.