User's Manual
Table Of Contents
- 1 G6 Overview
- 2 Operation
- To power on G6:
- OK Status
- Low Urgency Status
- High Urgency Status
- 3 Operational Notifications
- 4 Low Urgency Notifications
- 5 High Urgency Notifications
- 6 Gas Detection
- 7 Features
- 8 Device Settings
- 9 Maintenance
- 10 Firmware Updates
- 11 Support
- 12 Specifications
- 13 Legal Notices and Certifications
©2022 Blackline Safety Corp G6 Technical User Manual | 52
Uncontrolled when printed Rev 01
To replace the G6 gas sensor filter:
1. Using a flathead screwdriver, gently detach the gas
sensor faceplate by inserting the screwdriver head
between the faceplate and the bottom edge of G6
and twisting to loosen the attachment.
2. Remove and set aside the sensor faceplate.
3. Remove and discard the old filter, making sure to avoid
contact with the gas sensor surface.
4. Place the new filter over the sensor, ensuring that the
filter gasket is facing outwards from the device and
correctly aligned within the gas sensor socket.