User's Manual

16 || G7 BRIDGE TECHNICAL USER MANUAL
SETTINGS
PAIR NEW DEVICES
How do I pair new devices to G7 Bridge?
1. Turn on G7 Bridge
2. Press OK on G7 Bridge to open Bridge’s menu
3. Use the up and down arrows to navigate to pair new devices and press OK
4. Use the up and down arrows to navigate to start and press OK
5. G7 Bridge’s screen will say pairing started as it looks for devices
6. Turn on up to 5 G7x devices
NOTE: G7 Bridge can only connect to 5 G7x devices at once.
7. When G7x has been paired, you will notice the following:
 G7 Bridge’s main screen will show that it has connected devices
 The yellow warning alarm on G7x will silence
 G7x’s green connectivity light will be solid (not ashing)
 You will receive a message on G7’s screen that reads pairing succeeded
and shows Bridge’s network key
8. Press OK on G7 Bridge to stop pairing once all necessary devices have been paired.
If you are pairing more than 5 G7x devices, repeat steps 2-8 for all G7x devices.
DIAGNOSTIC TOOLS
Diagnostics contains information about the rmware version and advance satellite
information. This information is not required for typical operations.
LCD SLEEP MODE
What is sleep mode?
To maximize battery life, G7 Bridge will go into sleep mode two minutes after the last button
was pressed. Sleep mode will turn o the LCD screen to reduce power consumption.
How do I wake up G7 Bridge from sleep mode?
Press any button to wake the LCD screen from sleep mode.
NOTE: If the LCD screen does not wake up, the battery may be depleted and will require
charging.