CP-6 / CP-8 FIXED 1.
Thank you for choosing Gabor. The Gabor Fixed 1.5 NPT Mounting Plates offer a simple-to-attach solid steel plate that allows safe installation of universal 1.5 NPT mounts and extension columns. The durable steel construction supports up to 500 pounds, depending on the support structure, so you can easily hang a TV, monitor, or projector from your ceiling. If you have safety concerns about installing this product, contact a qualified professional or installation contractor.
Product Specifications Dimensions CP-6: 6 × 6 in. (15.2 × 15.2 cm) CP-8: 8 × 8 in. (20.3 × 20.3 cm) Material Steel Mount Compatibility 1.5 NPT Max Weight Capacity 500 lb. (226 kg) Parts List Tools and Hardware Mounting plate Drill Lag screws Nuts A 1X B 1X Stud finder Washers 3/16 in. (4.5 mm) Wood drill bit Concrete anchors 3/8 in. (10 mm) Concrete drill bit Framing channels Pencil Pinhead security set screw Hex key (5/32 in.
Overview CP-6 INCHES ( MM ) 6 152.4 0.41 x 0.73 10.5 x 18.5 4.2 105.5 1.5 NPT 6 152.4 2.08 52.75 0.92 23.45 0.77 19.45 2.23 56.75 0.7 17.3 4.5 113.5 CP-8 8 203.2 0.41 x 0.73 10.5 x 18.5 1.5 NPT 6.2 156.5 8 203.2 3.08 78.25 0.92 23.35 0.76 19.35 3.24 82.25 6.5 164.5 0.7 17.
Instructions You can easily attach the Fixed Mounting Plate to a wooden stud framed ceiling, a suspended ceiling, or into concrete. Make sure you do not attach the plate to a vertical mounting surface such as walls or angled ceilings. Important! Check the weight limitations of the supporting structure and mounting components to ensure you do not exceed the lowest weight capacity.
Mounting to a Suspended Ceiling Mount the plate from a suspended ceiling by using four 3/8-inch Grade 2 or better threaded rods, which are secured to framing channels spanning up to 5 feet by Grade 2 or better 3/8-inch channel nuts. 1. Screw a threaded rod into each channel nut. 2. Screw a nut onto each threaded rod. 3. Insert washers onto the threaded rods, and fit the plate onto the rods. 4. Rotate the nuts up and down the threaded rods to adjust the plate until it’s level. 5.
Mounting into Concrete 4X 4X 8X 8X Mount the plate into an 8-inch-thick concrete ceiling. Anchors must be installed into the concrete before installing the Gabor Fixed Mounting Plate. Warning! Make sure the concrete is structurally solid with no cracks or other defects, as this can result in personal injury or damage to equipment. 1. Use the plate’s mounting holes as a guide, and drill four holes into the concrete. 2. Insert an anchor into each hole, and then screw a threaded rod into each anchor. 3.
Attaching an Extension Column 1. Install a 1.5 NPT threaded extension column (not included) into the plate’s threaded collar. Tighten with at least four hand turns. 2. Use the included pinhead security set screw to lock the column in place, and tighten with the hex key. 3. Connect the mount of your TV, monitor, or projector, using the instructions included with the manufacturer’s manual for your equipment.
Safety Warnings • When installing this product, be sure to refer to the mounting instructions detailed in this manual; failure to abide by the mounting instructions may void the product’s warranty. • Do not exceed the maximum weight limit, as this can result in serious personal injury or damage to equipment. It is the installer’s responsibility to make sure all components attached to the Gabor Mounting Plates do not exceed 500 pounds (226 kg).
Ten-Year Limited Warranty This Gabor product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of ten (10) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.
