FM-2742 / FIXED WALL MOUNT For 27”- 42” Flat Panel Screens User Manual
Thank you for choosing Gabor. Thank you for choosing Gabor’s fixed flat panel screen wall mount. This heavy-duty wall mount has been engineered to provide your 27”-42” flatscreen monitor with sturdy, long-lasting support that can be relied upon for years of viewing enjoyment.
Welcome 3
Tools Required For Installation Product Specifications 1. Power Drill 3. Scissors • For Mounting 27”-42” Flat Panel Screens On Wooden Studs & Concrete Walls 2. Phillips Screwdriver 4. Socket Wrench Vesa Mounting Pattern Max.
Wall Mount M4 M5 Brackets M6 M8 Washer/ Spacer Washer/Bolt/Anchor K x4 A x4 C x4 E x4 G x4 I x4 B x4 D x4 F x4 H x4 J x4 L x4 M x4 Contents 5
Installation Instructions STEP 1: Installing Dual Mounting Brackets On Rear Of Flatscreen • 6 Begin by aligning both brackets on rear of flatscreen device, while ensuring that the screen is resting on a non-scratch surface. The appropriate bolts and washers should be selected by measuring the height, size and position of holes on rear of flatscreen device, and determining which bolts Installation Instructions and washers fit best.
Installation Instructions 7
• Upon final installation completion, you can tuck or trim cords away in position so they remain hidden behind flatscreen device, but only after completing step 4. TOP Hardware Configurations For Display With Flat Back: Install bracket directly to flatscreen device using only bolts and washers provided; align bolt with proper sized hole on washer. (Fig.
STEP 2: Positioning Mount Correctly On Wall • The optimal height to position a flatscreen device is by mounting it at eye-level of viewer. This can be accomplished in one of two ways: Eyelevel Height • Measure distance from seating area to viewing area to determine proper placement. The ideal position should place the center of the panel (where the diagonals meet) as close as possible to eye-level.
STEP 3: Installing Mount Directly On Wall • After confirming height positioning is appropriate by marking wall with a pencil, hold wall mount firmly against wall and use pencil to mark exact location of drill holes, using a bubble level to ensure a proper balance; then remove wall mount and pre-drill holes.
• Hold wall mount securely and begin inserting bolts into appropriate predrilled holes; use 1 bolt on each end of wall mount, while using appropriate anchors or washers.
STEP 4: Hanging Flatscreen Device On Wall Mount • 12 With mounting brackets fastened to rear of flatscreen device, lift entire flatscreen display over wall mount and - with the flatscreen positioned above the mount - hook upper section of brackets onto top part of wall mount. Installation Instructions • Gently lower flatscreen panel downwards; push lower section of brackets into place, allowing builtin latches to grip bottom of wall mount.
Installation Instructions 13
Safety Warnings 1 Do not use this product for any flat panel screen device other than what it is intended for; the exact specifications, size parameters and weight limits are found both on the product box and in the instruction manual 2 It is strongly recommended that this product be installed by a qualified professional or installation contractor; Gabor takes no responsibility for any product damage or personal injury resulting from mishandling, incorrect mounting, faulty assembly or improper use of this
Customer Support ONE-YEAR LIMITED WARRANTY: For more information or to arrange service, visit www.madebygabor.com or call Customer Service at 212-594-2353. Product warranty is provided by the Gradus Group. www.gradusgroup.com Gabor is a registered trademark of the Gradus Group. © 2014 Gradus Group LLC. All Rights Reserved.
WWW.MADEBYGABOR.
