LOW-PROFILE FIXED WALL MOUNT for Flat-Panel Screens User Manual
Thank you for choosing Gabor. The Gabor Low-Profile Fixed Wall Mount Series, available in 3 sizes, offer durable and discreet wall supports for displays measuring 30 to 90 inches and can hold a maximum weight ranging from 75 to 130 pounds. This low-profile mount offers a mounting depth of 1 inch (25 mm), ensuring that your display will hang nearly flush against the wall. If you have safety concerns about installing this product, contact a qualified professional or installation contractor.
Safety Warnings • Do not use this product for any flat-panel monitor device other than what it is intended for; the exact specification, size parameters, and weight limits are found both on the product box and in the instruction manual. • It is recommended that at least 2 people perform the installation process to prevent injury from mishandling or dropping of the product and/or flat-screen device.
Product Specifications Depth from Mounting Source 1 in. (25 mm) Material Steel Recommended Screen Sizes FM-LPM: 30-50 in. (76.2-127 cm) FM-LPL: 50-70 in. (127-178 cm) FM-LPX: 70-90 in. (178-229 cm) Weight FM-LPM: 2.54 lb. (1.15 kg) FM-LPL: 3.06 lb. (1.39 kg) FM-LPX: 4.24 lb. (1.92 kg) VESA Mounting Pattern FM-LPM: 75×75 mm to 400×400 mm FM-LPL: 75×75 mm to 600×400 mm FM-LPX: 75×75 mm to 800×600 mm Max Weight Capacity FM-LPM: 75 lb. (34 kg) FM-LPL: 99 lb. (45 kg) FM-LPX: 130 lb.
Overview A Required Tools Hammer 1/8-inch (3 mm) Wood drill bit Drill 1/2 in. (13 mm) crescent wrench 25/64-in. (10 mm) Concrete drill bit Wall Bracket Phillips screwdriver Left B C Display Brackets M4 × 12 mm screw L Right with drawstring latch 4X 4X 18 × 6.5 × 1.
Display/TV Placement Before installing the Gabor Low-Profile Fixed Wall Mount, you will need to determine the placement of your display and identify surrounding support structures for attachment. The optimal height to position a display is at the viewer'seye level. This can be accomplished in two ways: 1. Measure the distance from the seating area to viewing area. Ideally, the center of the display (where the diagonals meet) should be as close as possible to eye level. Eye level OR 2.
Attaching the Display/TV Brackets B I Selecting the Right VESA Mounting Hardware for Your Display A variety of screws are included to fit VESA standards on the backs of most displays. Select the M4, M5, M6 or M8, screws and washers that best fit your display. Hand-thread the screws to determine the correct diameter. Note: Attach the display brackets with the drawstring latches facing inward, towards each other. D E F G J K L M H If the screw is too short, it may not hold the display.
Attaching the Wall Bracket to Wooden Studs A N 3X O 3X Q 1X Wood studs run vertically inside the wall, 16 inches apart, behind the drywall or plaster. The wall bracket must be mounted to the wood studs, or the bracket could fall out and damage your display or cause personal harm. Three anchor screws are included for use with the FM-LPX, but for the FM-LPM and FM-LPL you will need only two anchor screws.
Wall brackets mounted to wooden studs, with correct screw placement 4 FM-LPM FM-LPL FM-LPX 9
Attaching the Wall Bracket to Concrete A N 3X O 3X P 3X Q 1X Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick. If the concrete exhibits cracks or other defects, this may result in failure of the concrete anchors and cause serious personal injury and damage your display. 1. Place the wall bracket up to the location marked for your display, and use a pencil to mark three drilling holes for the concrete anchors.
Mounting the Display on the Wall Bracket Important! We recommend that two people perform this step. Lift your display up to the wall bracket, and hang it from the top hooks of the display's brackets until the latchs click secure. Removing the Display from the Wall Bracket Important! We recommend that two people perform this step. To remove the display from the wall bracket, pull down on both drawstrings, and swing the display outward, and away from the wall.
One-Year Limited Warranty This Gabor product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
