TSM-1327 / FULL MOTION WALL MOUNT For 13”- 27” Flat Panel Screens User Manual
Thank you for choosing Gabor. Thank you for choosing Gabor’s full motion flat panel screen wall mount. This heavy-duty wall mount has been engineered to provide your 13”-27” flatscreen monitor with sturdy, long-lasting support that can be relied upon for years of viewing enjoyment.
Welcome 3
Tools Required For Installation Product Specifications 1. Power Drill 3. Tape Measure • For Mounting 13”-27” Flat Panel Screens On Wooden Studs & Concrete Walls 2. Phillips Screwdriver 4.
Mounting Bracket M4 A x4 M6 Wall Mount Spacer Long Bolt/ Lead Anchor Hex Key D x4 B x4 E x4 C x4 F x4 G x4 I x2 H x4 J x2 K x1 Contents 5
Installation Instructions STEP 1: Installing Dual Mounting Bracket On Rear Of Flatscreen • 6 Begin by separating mounting bracket from wall mount device. This can be accomplished by pressing and holding safety release latch found atop wall mount device; slide assembly upwards and away. Place wall mount device aside and proceed to next step.
Installation Instructions 7
• Note that bolts must be hand-fastened into holes with a screwdriver to avoid overtightening and possible damage. Hardware Configurations For Display With Flat Back: Install bracket directly to flatscreen device using only bolts and washers provided; align bolt with proper sized hole on washer. (Fig. 1) (Fig.
STEP 2: Positioning Mount Correctly On Wall • The optimal height to position a flatscreen device is by mounting it at eye-level of viewer. This can be accomplished in one of two ways: Eyelevel Height • Measure distance from seating area to viewing area to determine proper placement. The ideal position should place the center of the panel (where the diagonals meet) as close as possible to eye-level.
STEP 3: Installing Mount Directly On Wall • 10 After confirming height positioning is appropriate by marking wall with a pencil, hold wall mount firmly against wall and use pencil to mark exact location of drill holes, using built-in leveler to ensure a proper balance; then remove wall mount and pre-drill holes (see sidebar for specific mounting details regarding sheetrock and concrete walls).
Wall-Type Mounting Details Mounting To Wood Studs Under Sheetrock Wall: Pre-drill holes according to markings on wall with a 3mm drill bit; be sure pre-drilled holes are at least 30mm deep; use appropriate wall anchors to attach wall mount (please verify that included anchors are appropriate). Mounting To Solid Concrete Wall: Pre-drill holes according to markings on wall with a 12.
STEP 4: Hanging Flatscreen Device On Wall Mount • 12 With mounting bracket securely fastened to rear of flatscreen device, lift entire flatscreen display over wall mount and - with the flatscreen positioned above - slide mounting bracket into track found on wall mount and push downward until safety latch clicks into place.
STEP 5: Positioning Installed Wall Mount • Upon installation completion, secure power cord for flatscreen device by running it through the metal arch found on bottom of wall bracket and attach plug to power source.
Safety Warnings 1 Do not use this product for any flat panel screen device other than what it is intended for; the exact specifications, size parameters and weight limits are found both on the product box and in the instruction manual 2 It is strongly recommended that this product be installed by a qualified professional or installation contractor; Gabor takes no responsibility for any product damage or personal injury resulting from mishandling, incorrect mounting, faulty assembly or improper use of this
Customer Support ONE-YEAR LIMITED WARRANTY: For more information or to arrange service, visit www.madebygabor.com or call Customer Service at 212-594-2353. Product warranty is provided by the Gradus Group. www.gradusgroup.com Gabor is a registered trademark of the Gradus Group. © 2014 Gradus Group LLC. All Rights Reserved.
WWW.MADEBYGABOR.
