SDS

Material name: HYDROSTOP PREMIUMCOAT FINISH COAT
Version #: 08 Revision date: 08-08-2018
SDS 3021
SDS US
3 / 8
Chemical name
Common name and synonyms
CAS number
%
Titanium Dioxide
13463-67-7
5
Zinc Oxide
1314-13-2
1
2-N-Octyl-4-Isothiazolin-3-one
26530-20-1
0.3
Ammonium Hydroxide 20-30%
1336-21-6
0.1
PARAFFINIC PETROLEUM OIL
64742-54-7
0.1
Pure (Dibutyl Phthalate)
84-74-2
0.6
Non Hazardous Ingredients
50 to <60
4. First-aid measures
Inhalation
If breathing is difficult, remove to fresh air and keep at rest in a position comfortable for breathing.
Call a physician if symptoms develop orpersist.
Skin contact
Remove contaminated clothing immediately and wash skin with soap and water. Incase of
eczema or other skin disorders: Seek medical attention and take along these instructions.
Eye contact
Immediately flush with plenty of water for at least 15 minutes. If easy to do, remove contact lenses.
Rinse with water. Get medical attention if irritation develops and persists.
Ingestion
Rinse mouth. Get medical attention if symptoms occur.
Most important
symptoms/effects, acute and
delayed
Indication of immediate
medical attention and special
treatment needed
Upper respiratory tract irritation. Irritation of eyes and mucous membranes. Coughing. Skin
irritation. May cause an allergic skin reaction. Dermatitis. Rash.
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
General information
IF exposed or concerned: Get medical advice/attention. If you feel unwell, seek medical advice
(show the label where possible). Ensure that medical personnel are aware of the material(s)
involved, and take precautions to protect themselves. Show this safety data sheet to the doctor in
attendance. Wash contaminated clothing before reuse.
5. Fire-fighting measures
Suitable extinguishing media
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Unsuitable extinguishing
media
Specific hazards arising from
the chemical
Special protective equipment
and precautions for firefighters
Fire fighting
equipment/instructions
Do not use water jet as an extinguisher, as this will spread the fire.
During fire, gases hazardous to health may be formed.
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
In case of fire and/or explosion do not breathe fumes. Do not scatter thematerial.
Specific methods
Use standard firefighting procedures and consider the hazards of other involved materials.
General fire hazards
No unusual fire or explosion hazards noted.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Methods and materials for
containment and cleaning up
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Wear appropriate protective equipment and clothing during clean-up. Avoid breathing
mist or vapor. Do not touch damaged containers or spilled material unless wearing appropriate
protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant
spillages cannot be contained. For personal protection, see section 8 of the SDS.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth
and place into containers. Prevent entry into waterways, sewer, basements or confined areas.
Following product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.