SDS

Material name: UNITED COATINGS ROOF MATE BASE COATING
Version #: 02 Revision date: 11-17-2015
SDS 3032
SDS US
2 / 8
Common name and synonyms
CAS number
%
10605-21-7
0.1 to <1
26172-55-4
0.1 to <1
64742-54-7
0.1 to <1
50 to <60
4. First-aid measures
Inhalation
Move to fresh air. Call a physician if symptoms develop or persist.
Skin contact
Remove contaminated clothing immediately and wash skin with soap and water. In case of
eczema or other skin disorders: Seek medical attention and take along these instructions.
Eye contact
Rinse with water. Get medical attention if irritation develops and persists.
Ingestion
Rinse mouth. Get medical attention if symptoms occur.
Most important
symptoms/effects, acute and
delayed
Indication of immediate
medical attention and special
treatment needed
Upper respiratory tract irritation. Irritation of eyes and mucous membranes. Coughing. Skin
irritation. May cause an allergic skin reaction. Dermatitis. Rash.
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
General information
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves. Wash contaminated clothing before reuse.
5. Fire-fighting measures
Suitable extinguishing media
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Unsuitable extinguishing
media
Specific hazards arising from
the chemical
Special protective equipment
and precautions for firefighters
Fire fighting
equipment/instructions
Do not use water jet as an extinguisher, as this will spread the fire.
During fire, gases hazardous to health may be formed.
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Move containers from fire area if you can do so without risk.
Specific methods
Use standard firefighting procedures and consider the hazards of other involved materials.
General fire hazards
No unusual fire or explosion hazards noted.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Methods and materials for
containment and cleaning up
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Wear appropriate protective equipment and clothing during clean-up. Avoid breathing
mist or vapor. Do not touch damaged containers or spilled material unless wearing appropriate
protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant
spillages cannot be contained. For personal protection, see section 8 of the SDS.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth
and place into containers. Prevent entry into waterways, sewer, basements or confined areas.
Following product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Environmental precautions
Avoid release to the environment. Prevent further leakage or spillage if safe to do so. Avoid
discharge into drains, water courses or onto the ground. Inform appropriate managerial or
supervisory personnel of all environmental releases.