SDS

Material name: UNITED COATINGS ROOF MATE BASE COATING
Version #: 02 Revision date: 11-17-2015
SDS 3032
SDS US
3 / 8
7. Handling and storage
Precautions for safe handling
Avoid breathing mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid prolonged
exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Avoid
release to the environment. Observe good industrial hygiene practices.
Conditions for safe storage,
including any incompatibilities
Store in original tightly closed container. Store away from incompatible materials (see Section 10
of the SDS).
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Components
Type
Value
Form
Aqua Ammonia (10-30%)
(CAS 1336-21-6)
PEL
35 mg/m3
50 ppm
Calcium Carbonate (CAS
1317-65-3)
PEL
5 mg/m3
Respirable fraction.
15 mg/m3
Total dust.
US. ACGIH Threshold Limit Values
Components
Type
Value
Form
Aluminum Trihydroxide
(CAS 21645-51-2)
TWA
1 mg/m3
Respirable fraction.
Aqua Ammonia (10-30%)
(CAS 1336-21-6)
STEL
35 ppm
TWA
25 ppm
PARAFFINIC PETROLEUM
OIL (CAS 64742-54-7)
TWA
5 mg/m3
Inhalable fraction.
US. NIOSH: Pocket Guide to Chemical Hazards
Components Type Value
Form
Aqua Ammonia (10-30%)
(CAS 1336-21-6)
Calcium Carbonate (CAS
1317-65-3)
STEL 27 mg/m3
35 ppm
TWA 18 mg/m3
25 ppm
TWA 5 mg/m3 Respirable.
10 mg/m3 Total
Biological limit values
No biological exposure limits noted for the ingredient(s).
Appropriate engineering
controls
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Individual protection measures, such as personal protective equipment
Eye/face protection
If contact is likely, safety glasses with side shields are recommended.
Skin protection
Hand protection
Wear appropriate chemical resistant gloves.
Other
Wear appropriate chemical resistant clothing.
Respiratory protection
In case of insufficient ventilation, wear suitable respiratory equipment.
Thermal hazards
Wear appropriate thermal protective clothing, when necessary.
General hygiene
considerations
Always observe good personal hygiene measures, such as washing after handling the material
and before eating, drinking, and/or smoking. Routinely wash work clothing and protective
equipment to remove contaminants. Contaminated work clothing should not be allowed out of the
workplace.
9. Physical and chemical properties
Appearance
Physical state
Liquid.
Form
Liquid.