Operating Instructions

43
Troubleshooting en-us
Error code “:ƒ† is lit. Drain pump blocked or cover on the
drain pump is not locked in position.
Clean pump and lock cover correctly.
~ "Drain pump" on page 41
Error code “:ƒˆ is lit. Supply voltage too low. Not a dishwasher fault, have the supply
voltage and electrical installation checked.
A different error code is
indicated on the digital display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off dishwasher with the On/Off
switch (. After a short time restart the
dishwasher.
If the problem recurs, turn off the tap and
pull out the power supply plug.
Call customer service and mention the error
code.
Home network is not loading. Wi-Fi is not active on the router. Check the wireless network connection of
your router.
Wi-Fi display flashes Connection to the home network is
not available.
Activate the wireless network on your router.
Home Connect cannot be
implemented correctly.
Possible setting errors or a technical
fault.
Observe the supplied documents and
support information for Home Connect.
Refill indicator for salt P and/
or rinse-aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with dishwasher softener salt.
Sensor does not detect salt tablets. Use different dishwasher softener salt.
Refill indicator for salt P and/
or rinse-aid H is not lit.
Refill indicator switched off. Activation/deactivation ~ " , Rinse Aid"
on page 18, ~ " + Water softening system /
special salt" on page 16
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left in the dishwasher at
the end of the wash cycle.
Filter system or area under the filters
1j is blocked.
Clean filters and area underneath.
Wash cycle has not ended yet. Wait until wash cycle ends or reset.
Dishes not dry. No or too little rinse aid in the
dispenser.
Refill rinse aid.
Wash cycle selected without drying. Select wash cycle with drying.
~ "Dishwasher Cycles" on page 31
Water collecting in depressions on
the dishes and silverware.
Arrange dishes in a sloping position,
arrange affected dishes as sloping as
possible.
The combined detergent used has a
poor drying performance
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
extraDry to increase drying not
activated.
Activate extraDry. ~ "Dishwasher Cycle
Options" on page 32
Dishes were removed too early or
drying process had not ended yet.
Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
The eco rinse aid used has a limited
drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic dishes not dry. Inherent properties of plastic. Plastics do not absorb heat and therefore
do not dry as well.
Fault Cause Remedial action