Use and Care Manual & Installation Guide
Table Of Contents
- AF 2..
- Table of ContentsUse and care manual and installation instructions
- Use and care manual
- 9 Safety DefinitionsSafety Definitions
- IMPORTANT SAFETY INSTRUCTIONS
- WARNING
- General notes
- Fire Safety
- WARNING
- to reduce the risk of a range top grease fire:
- a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
- b) Always turn hood ON when cooking at high heat.
- c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
- d) Use proper pan size. Always use cookware appropriate for the size of the surface element.
- CAUTION
- to reduce the risk of a range top grease fire:
- WARNING
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- Burn Prevention
- Child Safety
- Cleaning Safety
- Safe use
- Proper Installation and Maintenance
- Proposition 65 Warning:
- Causes of Damage
- Protecting the environment
- Operating modes
- Operating the appliance
- Cleaning and maintenance
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- Cleaning agents
- Cleaning the metal grease filter
- Uninstalling metal grease filter
- 2 Open the lock on the metal grease filter and pull the metal grease filter out of the retainer at an angle. When you do this, take hold of the metal grease filter from underneath with your other hand.
- 3 Push and open the push-to-open mechanism again.
- Troubleshooting
- Customer service
- IMPORTANT SAFETY INSTRUCTIONS
- WARNING
- WARNING
- WARNING
- WARNING
- WARNING
- Risk of fire
- WARNING
- Risk of fire
- WARNING
- WARNING
- WARNING
- WARNING
- Note:
- Appliance Handling Safety
- Safety Codes and Standards
- Electric Safety
- Related Equipment Safety
- Proposition 65 Warning:
- Before you beginBefore you begin
- General NotesGeneral Notes
- Preparing the units
- Appliance dimensions and safety clearances
- 2 Remove cabinet base, if installed. Mark the fastening points on the inside of the cabinet and use a bradawl to make indentations where the holes are to be. To help you mark the fastening points, use the mounting piece provided.
- 2 Remove the tabs from the bottom of the mounting pieces. ©
- 3 Remove the tabs from the bottom of the mounting pieces. ª
- Electrical connection
- Installation
- Mounting the appliance
- 3 If required, shorten the filler strip to the required dimension. ©
- 2 Push in the fastening bolt gently with your fingers, and turn it until it comes out of the housing along with the spring.©
- 3 Carefully remove the appliance.
- 4 Fasten the filler strip in place.
- 5 Push in the fastening bolt and turn it 90°.
- 3 Fit the protective caps on the left and right. ª
- 4 Remove the protective caps from the fastening elements.
- Table des matièresNotice d’utilisation et de montage
- Notice d'utilisation
- 9 Définitions de sécuritéDéfinitions de sécurité
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- AVERTISSEMENT
- Instructions générales
- Sécurité-incendie
- AVERTISSEMENT
- pour réduire le risque d'incendie de graisse de cuisinière:
- a) Ne laissez jamais la surface de cuisson sans surveillance à des températures élevées. Les débordements causent de la fumée et les résidus graisseux peuvent s'enflammer.. Faites chauffer les huiles lentement à feu doux ou moyen.
- b) Faites toujours fonctionner la hotte lorsque vous cuisinez à feu vif.
- c) Nettoyez les ventilateurs régulièrement. Ne laissez pas la graisse s'accumuler sur le ventilateur ou sur le filtre.
- d) Utilisez des casseroles de taille appropriée. Utilisez toujours des récipients adaptés à la taille de la surface de cuisson.
- ATTENTION
- pour réduire le risque d'incendie de graisse de cuisinière:
- AVERTISSEMENT
- AVERTISSEMENT
- Risque d'incendie
- AVERTISSEMENT
- Risque d'incendie
- AVERTISSEMENT
- Risque d’incendie
- AVERTISSEMENT
- Risque d'incendie
- AVERTISSEMENT
- Risque d’incendie
- AVERTISSEMENT
- Risque d'incendie
- AVERTISSEMENT
- Prévention des brûlures
- Sécurité des enfants
- Consignes en matière de nettoyage
- Sécurité à l'utilisation
- Installation et entretien corrects
- Avertissement issu de la proposition 65 :
- Causes des dommages
- Protection de l'environnement
- Modes de fonctionnement
- Utilisation de l'appareil
- Nettoyage et entretien
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- Produits de nettoyage
- Nettoyage du filtre à graisse métallique
- Retirer le filtre à graisse métallique
- 2 Déverrouiller le filtre à graisse métallique et le retirer de sa fixation en l'inclinant. Placer l’autre main dessous pour saisir le filtre à graisse métallique.
- 3 Appuyer de nouveau sur le mécanisme d’ouverture par pression et l'ouvrir.
- Anomalies, que faire ?
- Service après-vente
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- AVERTISSEMENT
- AVERTISSEMENT
- AVERTISSEMENT
- AVERTISSEMENT
- AVERTISSEMENT
- Risque d'incendie
- AVERTISSEMENT
- Risque d’incendie
- AVERTISSEMENT
- AVERTISSEMENT
- AVERTISSEMENT
- AVERTISSEMENT
- Remarque :
- Sécurité de manutention des appareils
- Codes et normes de sécurité
- Sécurité électrique
- Équipement de sécurité
- Avertissement issu de la proposition 65 :
- Avant de commencerAvant de commencer
- Instructions GénéralesInstructions Générales
- Préparation du meuble
- Dimensions de l'appareil et distances de sécurité
- 2 Si présent, retirez le fond du meuble. Tracez les points de fixation sur les parois intérieures du meuble et pré-percez-les avec un poinçon. Utilisez l'élément de fixation joint pour tracer les points de fixation.
- 2 Retirez les pattes sous les éléments de fixation. ©
- 3 Retirez les pattes sous les éléments de fixation. ª
- Branchement électrique
- Installation
- Accrochage de l'appareil
- 3 Si nécessaire, raccourcissez la baguette murale à la dimension requise. ©
- 2 Enfoncez légèrement le boulon de fixation avec les doigts et tournez jusqu'à ce qu'il s'enlève du boîtier avec les ressorts.©
- 3 Retirez l'appareil avec précaution.
- 4 Vissez fermement la baguette murale.
- 5 Enfoncez le boulon de fixation et tournez-le à 90°.
- 3 Encliquetez les capuchons à gauche et à droite. ª
- 4 Ôtez les capuchons des fixations.
- ÍndiceInstrucciones de uso y montaje
- Manual de instrucciones
- 9 Definiciones de seguridadDefiniciones de seguridad
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- ADVERTENCIA
- Indicaciones generales
- Seguridad para evitar incendios
- ADVERTENCIA
- para reducir el riesgo de incendio ocasionado por la grasa en la estufa:
- a) Nunca deje las unidades de la superficie sin vigilancia en valores altos. Los derrames por hervor producen humos y salpicaduras grasosas que pueden prenderse fuego. Caliente los aceites despacio a temperaturas bajas o medianas.
- b) Siempre encienda la campana al cocinar a una temperatura alta.
- c) Limpie los ventiladores extractores con frecuencia. No se debe permitir la acumulación de la grasa en el ventilador ni en el filtro.
- d) Use el tamaño de cacerola adecuado. Siempre use utensilios de cocina apropiados para el tamaño del elemento de la superficie.
- ATENCION
- para reducir el riesgo de incendio ocasionado por la grasa en la estufa:
- ADVERTENCIA
- ADVERTENCIA
- Peligro de incendio
- ADVERTENCIA
- Peligro de incendio
- ADVERTENCIA
- Riesgo de incendio
- ADVERTENCIA
- Peligro de incendio
- ADVERTENCIA
- Riesgo de incendio
- ADVERTENCIA
- Peligro de incendio
- ADVERTENCIA
- Prevención de quemaduras
- Seguridad de los niños
- Seguridad en la limpieza
- Seguridad durante su uso
- Instalación y mantenimiento adecuados
- Advertencia en virtud de la Proposición 65:
- Causas para los daños
- Protección del medio ambiente
- Modos de funcionamiento
- Operar el equipo
- Limpieza y mantenimiento
- 9 ADVERTENCIA
- 9 ADVERTENCIA
- 9 ADVERTENCIA
- 9 ADVERTENCIA
- Productos de limpieza
- Limpiar los filtros metálicos para grasa
- Desmontar el filtro de metal antigrasa
- 2 Abrir el bloqueo del filtro de metal antigrasa e inclinar el filtro de metal antigrasa para sacarlo de la sujeción.Agarrar por debajo el filtro de metal antigrasa con la otra mano.
- 3 Volver a presionar el mecanismo Push-to-open y abrir.
- ¿Qué hacer en caso de fallas?
- Servicio al Cliente
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- ADVERTENCIA
- ADVERTENCIA
- ADVERTENCIA
- ADVERTENCIA
- ADVERTENCIA
- Peligro de incendio
- ADVERTENCIA
- Riesgo de incendio
- ADVERTENCIA
- ADVERTENCIA
- ADVERTENCIA
- ADVERTENCIA
- Nota:
- Seguridad de manejo del electrodoméstico
- Códigos y normas de seguridad
- Seguridad eléctrica
- Seguridad del equipo relacionado
- Advertencia en virtud de la Proposición 65:
- Antes de empezarAntes de empezar
- Información GeneralInformación General
- Preparación de los muebles
- Dimensiones del aparato y distancias de seguridad
- 2 Retirar el panel inferior del armario si cuenta con él. Trazar los puntos de fijación en los interiores del armario y marcarlos con un buril. Para marcar los puntos de fijación, utilizar la pieza de fijación adjunta.
- 2 Extraer las lengüetas inferiores de las piezas de fijación. ©
- 3 Extraer las lengüetas inferiores de las piezas de fijación. ª
- Conexión eléctrica
- Instalar
- Enganchar el aparato
- 3 En caso necesario, acortar el listón terminal de la pared a la medida requerida. ©
- 2 Presionar levemente y girar el perno de fijación con los dedos hasta que se suelte de la carcasa junto con el resorte.©
- 3 Extraer con cuidado el aparato.
- 4 Atornillar el listón terminal de la pared.
- 5 Presionar el perno de fijación y girarlo 90°.
- 3 Enganchar los tapones protectores a la izquierda y la derecha. ª
- 4 Retirar los tapones protectores de las fijaciones.
17
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged
into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether
the wall receptacle is properly grounded, the
customer should have it checked by a qualified
electrician.
If required by the National Electrical Code (or
Canadian Electrical Code), this appliance must be
installed on a separate branch circuit.
WARNING
To reduce the risk of fire or electric shock, do not use
this fan with any solid-state speed control device.
Installer – show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
‒ Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
‒ Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply
with all applicable codes.
WARNING
Risk of electric shock
Parts inside the appliance can have sharp edges. The
connection cable can be damaged. Do not bend or
pinch connection cables during installation.
Related Equipment Safety
Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packaging
material.
The appliance should only be used if installed by a
qualified technician in accordance with these
installation instructions. The manufacturer is not
responsible for any damage resulting from incorrect
installation.
Never modify or alter the construction of the
appliance. For example, do not remove leveling legs,
panels, wire covers or anti-tip brackets/screws.
Proposition 65Warning:
This product may contain a chemical known to the
State of California, which can cause cancer or
reproductive harm. Therefore, the packaging of your
product may bear the following label as required by
California:
&DQFHUDQG5HSURGXFWLYH+DUPZZZ3:DUQLQJVFDJRY
67$7(2)&$/,)251,$352326,7,21:$51,1*
:$51,1*