Operating and assembly instructions AH 590-720 Freely Suspended Insular Hood
AH 590-720 6. Assembly instructions 6.1 Technical data 6.
6. Assembly instructions 6.1 Technical data Weight without support frame and LK: 35 kg Weight with support frame and LK: max. 60 kg Dimensions: 47 3/16 ´ ´ x 27 1/2 ´ ´ / 1198 x 700 mm Electrical connection Pay attention to the rating plate data. The appliance must only be connected by an authorised specialist. The specialist is responsible for perfect functioning of the appliance at its installation location.
6.2 Installation WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a.) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. b.) Sufficient air is needed for proper combustion end exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
Flexible aluminium pipes, corrosion-protected sheet metal pipes and exhaust air pipes whose material conforms to fire B1 in accordance with DIN 4102 can be used. Exhaust air pipes should have a nominal diameter of 6 ´ ´ / 150 mm.
Installation above gas cooker / gas hob Installation of the appliance above a gas cooking device must conform to national safety regulations. A minimum distance of 30 ´ ´ / 762 mm between the hood and gas appliance must be observed. Gas appliances may only be used under the extractor hood when pots and pans are placed on them! Operation above gas cooker / gas hob During operation the heat load of all hotplates and oven must not exceed 13.5 kW.
(7 7/8") 200 (13 5/8") 346 Note: the extractor hood is to be installed to a kitchen ceiling or suspended ceiling. Ensure that the ceiling is capable of providing a firm hold for a maximum weight of hood and accessories of 60 kg. Before marking the securing holes, make sure that no electricity wires or water pipes or other wires/ pipes are laid at the drilling points in the ceiling. Before installation check the enclosed wall plugs and screws are suitable for your ceiling.
Fig. 21 Fig. 22 18 6. Adjust the support frame to the desired height and secure with 8 screws. The length of the support frame can be adjusted in steps of 3 / 4 ´ ´ / 20 mm from 15 3/ 16 ´ ´ / 386 mm to 25 7/16 ´ ´ / 646 mm (Fig. 21). Note: ensure that the minimum distance between the hob and the extractor hood is maintained – 24 ´ ´ / 600 mm for an electric hob and 30 ´ ´ / 762 mm for a gas hob 7.
11. Adjust the hood to the final position and attach it with all 4 screws to the ceiling (Fig. 23). 12. Connect the air outlet pipe. 13. Connect the hood to the electricity supply. 14. Pull the top duct unit up into its final position. Secure the top duct unit with 4 screws on the support frame (Fig. 24). Note: avoid scratches when pulling the elements apart by placing the assembly template, for example, over the top edge of the bottom duct to protect it. 15.
GAGGENAU HAUSGERÄTE GMBH P.O. BOX 10 02 50 · D - 80076 MÜNCHEN GERMANY Y (0 89) 45 90-01 FAX (0 89) 45 90-23 47 5551 McFADDEN AVENUE HUNTINGTON BEACH, CA 92649 USA Y (800) 828-9165 · FAX (714) 901-0979 www.gaggenau.