Use and Care Manual

43
Cleaning and maintenance en-us
10. Insert the drain filter and turn right to the stop. Press
™ to confirm.
The cleaning program is complete. Allow the appliance to
cool down. Then polish the oven cavity and the glass with
a soft cloth.
Note: The final rinse cycle may leave white streaks in the
oven cavity and on the glass after drying. This depends
on the water hardness. Remove the white streaks with a
damp cloth
Dispose of the empty cleaning cartridge in accordance
with regional regulations for household waste.
Causes for unsatisfactory cleaning results
If the oven cavity is still not clean once the cleaning
program has ended, use the chart below to help you
identify the causes. Then insert a new cleaning cartridge
and start the cleaning program again.
Drying program
With the drying program, you can dry the oven cavity
quickly.
The drying program takes 20 minutes.
Starting the drying program
1. Set the function selector to S. Select the drying
program with the rotary selector.
2. The j symbol is displayed. Confirm with ™.
3. The drying time of 20 minutes appears. Touch I to
start. The drying time elapses on the display. The lamp
in the oven cavity remains off.
4. A signal sounds after 20 minutes. A message appears
in the display. Confirm with ™.
The drying program has ended. Allow the appliance to
cool down. Then polish the oven cavity and the panel with
a soft cloth.
Descaling program
Regular descaling keeps the appliance in good
condition. The descaling program descales and rinses
the appliance fully automatically.
Depending on the type of water and your use of the
appliance, a message in the display reminds you to run
the descaling program.
To prevent damage to the appliance, the operating modes
that use steam are disabled after this message has been
repeated. You can still use the appliance to run operating
modes that do not require steam. Only once the
descaling program has been run can the appliance be
used again without restrictions.
The descaling program takes 1 hour 45 minutes from
beginning to end.
For the descaling program, you require special descaling
tablets. These are available from Customer Service or
from our online shop (17002490, set with four descaling
tablets).
Possible cause Solution
Locking cap on the
cleaning cartridge
The locking cap has not been
removed from the cleaning car-
tridge.
Once the cleaning program has
ended, remove the cartridge
from the appliance. Do not reuse
the cartridge. Dispose of the car-
tridge in accordance with the
local regulations.
9 WARNING
Risk of injury!
To prevent the detergent
from coming into contact
with your skin or eyes, do
not remove the locking cap
from a spent cartridge.
Drain filter not
inserted
The drain filter must remain
inserted in the oven cavity floor
while the cleaning program is in
progress.
Power failure Following a power cut that lasts
longer than 3 minutes, the clean-
ing program is ended with a
short program.
Stubborn burnt-on
food residues
Run the cleaning program again
to remove stubborn food resi-
dues.
'U\LQJSURJUDP

_