Instructions for Use

en-us Troubleshooting
36
Issue Cause and troubleshooting
The core temperature probe is in-
serted; the display shows 210°F
(99°C).
Moisture on the core temperature probe plug or on the socket in the oven cavity.
▶ Insert and remove the plug for the core temperature probe in the socket in the
oven cavity several times.
The core temperature probe is in-
serted, but the display does not
show the core temperature probe
symbol .
Moisture on the socket in the oven cavity.
▶ Insert and remove the plug for the core temperature probe in the socket in the
oven cavity several times.
No steam is visible. Water vapor above 212°F (100°C) is not visible.
▶ This is normal.
No action required.
"Steam removal" function does not
work.
Steam removal is only possible if the temperature in the oven cavity is below
265°F (130°C).
▶ This is normal.
Powerful steam release at the top
of the door.
You have changed the operating mode.
▶ This is normal.
No action required.
Powerful steam release at the side
of the door.
The door seal is dirty or loose.
1. Clean the door seal.
2. Insert the door seal into the groove.
Humming noise when switching
on.
The drain pump starts running.
▶ Normal operating noise
No action required.
The appliance has been switched off for a few days. Automatic rinsing during initial
use.
▶ Normal: Automatic rinsing during initial use.
No action required.
A whistling noise occurs during
heating.
Noises may occur during steam generation.
▶ This is normal.
No action required.
A "plop" sound can be heard dur-
ing cooking.
Tension expansion when the temperature difference is large.
▶ This is normal.
No action required.
Steaming is not possible. Build-up of limescale in the appliance. The appliance must be descaled to avoid
damage to the appliance.
▶
Start the descaling program → Page32 .
The appliance is no longer produc-
ing steam correctly.
Build-up of limescale in the appliance.
▶
Start the descaling program → Page32 .
The lighting does not work. The lighting is defective.
▶ Call Customer Service.
→ "Customer Service", Page57
The display shows the error mes-
sage "Exx".
An error occurred.
1. If the display shows an error message, turn the function selector to ⁠.
a If the display no longer shows the error message, it was a one-off problem.
2. If the display continues to show or repeatedly shows the error message, contact
customer service → Page57 and provide them with the error code.
Water drips out when you open the
appliance door.
The collecting channel on the underside of the door pane is full.
▶ Dry the collecting channel with a sponge.
An unpleasant smell occurs during
heating.
The appliance is new.
▶ Before using it for the first time, heat the appliance at 60% humidity and 395°F
(200°C) for one hour.
→ "Heating up the appliance", Page16