Operation Manual

17
Refill display does not light up.
Rinse aid refill indicator switched off.
(see auto 3in1 chapter)
Salt refill indicator switched off.
(see auto 3in1 chapter)
Water remains inside appliance after
programme has ended
Blockage or kink in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. Wait for the
programme to end (numerical display will
indicate 0).
Perform “Reset” function.
... during washing
Unusual amount of foam is created
Normal washing up liquid has been poured into
the rinse-aid container.
Remove any spilled rinse aid with a cloth as it
could otherwise lead to excessive foaming
during the next washing cycle.
Appliance stops suddenly while washing is
taking place
Cut in electricity supply to appliance.
Water supply has been interrupted.
Knocking sound can be heard while washing is
taking place
A spray arm is knocking against the dishes
inside the appliance.
Rattling sound can be heard while washing is
taking place
Crockery has not been stacked properly inside
the appliance.
Knocking sound coming from inlet valves
This is caused by the way the water pipes have
been laid and it has no effect upon the way the
appliance functions. There is no remedy for this.
... with the dishes, cutlery, etc.
Remnants of food are stuck to the dishes,
cutlery, etc.
Dishwasher was not loaded properly. Jets of
water could not reach all parts of the dishes,
etc.
Too many items in the rack.
Items in the rack were touching each other.
Not enough detergent was added to dispenser.
Selected wash programme was not intensive
enough.
Rotation of spray arm was obstructed by dish,
etc.
Nozzles in spray arm are blocked by remnants
of food.
Filters are blocked.
Filters have been incorrectly fitted.
Waste-water pump is jammed.
Plastic items are discoloured
Not enough detergent was added to dispenser.
White stains are left on crockery, glasses have
a milky appearance
Not enough detergent was added to input
compartment.
Amount of rinse-aid was set too low.
Although water is quite hard, no salt has been
put in appliance.
Water softener was set too low.
Lid on salt container is not screwed tight.
If you used a phosphate-free detergent, try a
detergent containing phosphates and compare
results.
Dishes, cutlery, etc. have not been dried
Selected programme did not include drying
function.
Amount of rinse-aid was set too low.
Items were removed from dishwasher too soon.
Glasses have a dull appearance
Amount of rinse-aid was set too low.
Tea stains or traces of lipstick have not been
completely removed
Detergent does not have a sufficient bleaching
effect.
Washing temperature was set too low.
Traces of rust on cutlery
Cutlery is not sufficiently rustproof.
Salt content in washing water is too high.
Lid on salt container is not screwed tight.
Too much salt was spilt while filling container.
Glasses become clouded and discoloured;
coating cannot be wiped off
Unsuitable detergent was used.
Glasses are not dishwasher-proof.
Smears left behind on glasses and cutlery;
glasses have acquired a metallic appearance
Amount of rinse-aid set too high.