Operation Manual

7
Adding rinse aid
Rinse aid is used in the rinsing cycle to ensure clear
glasses and stain-free utensils.
Open the lid of the rinse-aid dispenser 29 by
pressing the button on the rinse-aid lid and lifting up
the lid.
Pour the rinse-aid into the filler hole until the level
indicator turns dark.
Close the lid, ensuring that you hear it snap closed.
rinse–aid control
Use only rinse aid for domestic dishwashers. Spilt rinse
aid may result in excessive foam formation in the next
rinse cycle. Therefore, remove any spilt rinse aid with a
cloth.
Convenient rinse-aid filling procedure
with half-open door
Open the rinse-aid lid and pull out the hinged filling
aid until it locks into position.
Slowly fill with rinse aid but do not overfill.
Close the rinse-aid lid until it clicks shut.
Set Amount of Rinse Aid
The amount of rinse aid is set at the factory to 4.
Only change this setting if streaks b or water stains y
remain on the dishes.
Hold the Programme button
3
and press the main
switch
1
.
Release both buttons.
In order to change the setting, press the Programme
button
3
.
Each time you press the button the value increases
by one step; once a value of is reached the
indicator jumps back to (Off: The rinse aid
fill indicator
6
does not show a need to refill).
Switch off the main switch
1
. The set value is
stored within the device.
Note
Only switch off the rinse aid indicator if you are using
cleaning products with integrated rinse aid!