Use and Care Manual

32
en-us Operating the Dishwasher
1 Operating the Dishwasher
Operati ng the Dishwasher Note: With hidden controls, the door must be opened
before changing settings and closed after changing
settings.
 WARNING
Risk of injury!
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped
and steam has subsided.
Protection against unintentional
operation
Your dishwasher is equipped with a function that helps
to prevent unintentional operation (e.g. by children).
After starting the dishwasher, the dishwasher door has
to be closed within 4 seconds, otherwise the operation
will be paused. There will be a signal on the control
panel advising you to press the Start button again and
close the door.
This function will be activated when:
ʑ pressing Start to begin a wash cycle
ʑ setting Delay time and pressing Start
ʑ opening the door while Delay time is active
ʑ opening the door during a wash cycle.
Note: This function cannot be deactivated.
Operating the touch buttons
Buttons are sensitive and should be touched gently.
Avoid any grease or food particles resting on the
buttons as they could activate the dishwasher.
Wiping and cleaning can also activate the dishwasher.
For best results, use bare, clean hands when touching
the buttons.
To clean the touch buttons wipe them with a dry or
slightly damp cloth.
Changing the settings
The dishwasher has been preset with certain settings
for your convenience. You can change these factory
settings.
Change the setting as follows:
1. Open the door.
2. Switch on On/Off button (.
3. Press Info button 8 for 3 seconds until the
following text is indicated in the digital display @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing button > ` until the required setting
is indicated in the display window at the top @.
5. Make the selection with setting buttons + -X.
6. Press and hold the Info button 8 for 3 seconds.
The chosen setting has now been stored.
Tip: If you change several settings, first make all
changes in succession. Now press the Info button 8
for 3 seconds. This saves all set values in the appliance.