Use and Care Manual

16
en-us Water softening system / special salt
Remote start button
Once the dishwasher is connected to the home network,
press the remote start button h to control the
dishwasher from your device.
If the dishwasher has still not logged into Home
Connect, access the Home Connect settings by
pressing the remote start button h.
Follow the directions in the supplied Home Connect
leaflet.
Note: Your dishwasher is protected against
unintentional operation. If the appliance door remains
open for more than 4 seconds after pressing the
Remote Start buttonh, the operation will be paused.
Press the Remote Start button h again and close the
appliance door to resume control. Also see section
Notes
▯ When the login process is complete, the Remote
Start button h goes out.
▯ To activate the remote control, press the Remote
Start button h.
▯ If the Home Connect Assistant was aborted during
start-up, press the Remote Start button h again.
▯ If the connection to the router fails, | flashes on the
display.
Wi-Fi without a connection to the Home
Connect server ƒ
Wi-Fi without a connect i on to the Home Connect ser v er You can use the Home Connect App to disconnect
from the Home Connect server.
The appliance is then locally connected to your mobile
device without any connection to the Home Connect
server.
Note: If you did not deactivate the connection to the
Home Connect server, check your Internet connection.
Remote diagnosis ~
Remot e di a gnos i s Customer Service can use Remote Customer Service~
to access your appliance if you contact them.
Notes
▯ You have to confirm Customer Service access on
your appliance.
▯ You can switch off Remote Customer Service ~
using the On/Off switch ( or deactivate Customer
Service access in the Home Connect App.
+ Water softening system / special salt
Water softening system / special salt To ensure good rinsing results, the dishwasher requires
soft water, i.e. water which is low in lime, otherwise
limescale will be deposited on the utensils and interior
container. Tap water above 7° dH (1.2 mmol/l) must be
softened. The water is softened with special salt
(regeneration salt) in the water softening system
of the dishwasher. The setting and therefore the
required amount of salt depends on the degree of
hardness of your tap water (see following water
hardness table).
Water hardness table








:DWHU
KDUGQHVV
YDOXH(
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW