Use and Care Manual

52
en-us Installation and connection
5 Installation and connection
Installati on and connecti on The dishwasher must be connected correctly, otherwise
it will not function properly. The specifications
for the inlet and outlet as well as the electrical
connected loads must correspond with the required
criteria as specified in the following paragraphs or in
the installation instructions.
Install the appliance in the correct sequence:
1. Checking appliance on delivery
2. Installation
3. Drainage connection
4. Tap water connection
5. Electrical connection
Parts included
If you have any complaints, contact the dealer from
whom you purchased the appliance or our customer
services department.
▯ Dishwasher
▯ User manual
▯ Installation instructions
▯ Quick reference guide*
▯ Warranty*
▯ Installation materials
▯ Steam guard plate*
▯ Rubber apron*
▯ Power cord
* depending on the features of your dishwasher
Safety instructions
Please refer to the Important Safety Instructions for
installation that are included in the separate Installation
Instructions for your appliance.
Delivery
Your dishwasher has been checked
thoroughly in the factory to ensure that it is in working
order. This may cause small water stains. These will
disappear after the first wash cycle.
Technical specifications
▯ Weight:
up to 132 lbs (60 kg)
▯ Voltage:
120 V, 60 Hz
▯ Connected load:
1,440 W.
▯ Circuit breaker:
12 A
▯ Power input:
Complies with the latest regulations (EU) for energy
label and ecological design at the time of placing on
the market.
Additional functions and settings may increase
power input and times.
▯ Water pressure:
at least 7.25 PSI (0.5 bar), maximum 145 PSI (10
bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
▯ Inlet rate:
minimum 2.65 gallons/minute (10 liters/minute)
▯ Water temperature:
Cold water.
Hot water:
Maximum temperature 140° F (60 °C).
▯ Capacity:
12–15 place settings (depending on the features of
your dishwasher).
Off-mode / standby mode 0.50 W
Left-on mode 0.50 W
Networked standby 2.00 W
Duration of left-on mode 0 min
Time after which appliance
is switched to networked
standby mode
2 min