Use and Care Manual

17
Before Calling for Service en-us
After the drying proce-
dure, the appliance dis-
plays the ¢ and …
symbols.
One drying cycle alone was not
sufficient.
Wait until the … symbol is no
longer lit up. Then start another
drying cycle.
The vacuum in the plas-
tic bag is not retained.
The bag is bad. Sharp parts of the food (for
example bones) may poke holes
in the bag.
Check the bag for damage. Use a
different bag if it is damaged. If
the damage is caused by sharp-
edged parts of the food, as far as
possible, position these in the
bag in such a way that they can-
not damage the wall of the bag.
The heat-sealed seam
is bad.
The heat-sealing time you have
selected is unsuitable for the
plastic from which the bag is
made.
Select a different heat-sealing
time.
There is liquid, grease or crumbs
along the heat-sealed seam. The
bag has creases along the heat-
sealed seam.
Make sure that the bag is dry,
that it has no creases, and that it
is positioned fully on the heat-
sealing bar.
Use a different bag. Fold over
the edge of the bag by 1¼ in
(3 cm) before you fill it.
The lid cannot be
opened.
A slight vacuum has formed and
it is holding the lid closed.
Do not use force or tools to open
it. Initiate vacuum-sealing again
and then cancel it immediately.
Disconnect the appliance from
the power supply. Wait
30 seconds and then start up the
appliance again.
Touch the ÿ symbol for more
than 5 seconds. The system is
reset.
Fault Error Causes Possible remedy