Use and Care Manual

28
en-us Faults – what to do?
Ice maker
--------
The ice maker is not functioning.
Ice cube production is switched off. Switch on ice cube production.
Freezer compartment is too warm. Set the temperature lower.
~ "Operating the appliance" on page 15
Ice cube container is not properly inserted. Insert ice cube container fully.
Ice maker without power. Call customer service.
~ "Customer service" on page 29
No water supply. Check water connection and contact technician if nec-
essary.
Low water pressure. Only connect appliance to pipes with sufficient water
pressure.
Kink in water hose. Turn off water supply, straighten out kink. Replace
water hose, if necessary.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there
will be too few in the ice cube container.
It takes around 24 hours for an empty ice cube con-
tainer to fill up.
Ice cube production stops even though the ice cube
container is still not full.
Do not store the ice shovel on the ice in the ice cube
container. Otherwise, the sensor will not detect the
actual fill level of the container.
Low water pressure. Only connect appliance to pipes with sufficient water
pressure.
The water filter is blocked or needs to be replaced. Replace water filter.
Freezer compartment is too warm. Set the temperature lower.
~ "Operating the appliance" on page 15
Water is leaking out of the appliance.
Water connection is not tight. Check if the connections are fastened firmly and the
water hose is undamaged.
If the water hose is damaged, contact customer service
and have it replaced. Replacement must be performed
by customer service or a similarly qualified person
only.Use original parts supplied by the manufacturer
only.