Use and Care

14
Booster function
This function will heat large amounts of water faster
than at heat level
12. The boost function temporarily
increases the maximum output of the selected cooking
zone.
This function can be activated for all cooking zones
only when the other cooking zone of the same group
is activated (see figure).
Turning on: Push in the control knob of the desired
cooking zone and turn it to position Ž. The Ž symbol
appears on the cooking zone display of the desired
cooking zone. An acoustic signal indicates that the
booster function has been activated.
Turning off: Turn control knob to any other heat level.
The Ž symbol goes out on the cooking zone display.
If the booster function is unavailable, it can't be
selected. The Ž symbol on the cooking zone display
blinks for 2 seconds and then disappears.
Note: Under certain circumstances, the booster
function turns off automatically to protect the
cooktop's electronic components from overheating.
The booster function doesn't turn on automatically
when it becomes available again. To turn it on
manually, first set the control knob to any other heat
level and then select the booster function again
Timer
Use the built-in timer like a kitchen timer. You can set
the duration for up to 90 minutes.
Note: The timer doesn't serve to automatically turn off
the cooking zone.
Setting duration
The timer is controlled using the touch keys on the
cooktop. Each tap of a touch key is confirmed by an
acoustic signal.
The timer is ready for use once at least one cooking
zone is active.
1 To activate the Š touch key, turn on at least one
cooking zone.
2 Tap the Š touch key. Notification ‹‹, and touch
keys A and @ are activated.
3 Set the desired duration by briefly touching the
sensor keys A or @.
Tip:
Touch and hold the touch keys A or @ to increase
or decrease the set duration more rapidly.
Note: If after 15 seconds nothing is inputted, the
timer will automatically turn off.






