Instruction Manual

13
Trouble shooting
en
Trouble shooting
Trouble shooti ng m Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers.
If the appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Contact the after-
sales service.
Faults often have simple explanations. Please read the
information in the table before calling the after-sales
service.
--------
Disruption Possible cause Solution
The appliance is not working No connection to the remote fan
unit.
Check whether the plugs of the connection cable
are properly inserted.
Power failure Check whether other kitchen appliances are work-
ing.
The fuse/circuit breaker is faulty Check in the fuse box to make sure that the fuse/
circuit breaker for the appliance is in working order.
After the appliance has been switched
off, the illuminated ring flashes white
slowly 3 times and an audible signal
sounds.
The metal grease filter is satu-
rated.
Clean the metal grease filter. ~
"Cleaning and
maintenance" on page 11
After the appliance has been switched
off, the illuminated ring flashes white
rapidly 6 times and an audible signal
sounds.
The activated charcoal filter in the
remote fan unit is saturated.
Change the activated charcoal filter in the remote
fan unit. ~ "Cleaning and maintenance"
on page 11
The appliance switches itself off while in
use; the illuminated ring is flashing
orange and white alternately
Safety switch-off function:
The controls on the appliance
have not been used for a long
time
Turn the control knob to 0, then switch it back on (if
you wish to continue using the appliance)
The appliance remains off after a
power failure
Turn the control knob to 0, then switch it back on (if
you wish to continue using the appliance)
Appliance runs in automatic mode, illu-
minated ring flashes orange
Automatic sensor is faulty Turn the control knob to 0, then switch it back on
If the illuminated ring continues flashing after you
have switched the appliance back on, contact the
after-sales service