INSTRUCTIONS MANUAL US/CANADA

22 ENGLISH
Warning! Never drink the descaling solution or
any products dispensed until the cycle has been
carried out to the end.
1. Remove the lter holder from the unit by turning
it from right to left.
2. Remove and empty the water tank (see the
chapter "Cleaning the water tank").
3. Pour HALF the content of the descaling
solution into the water tank and ll it with fresh
water up to the max level.
4. Turn on the machine by pressing the on / off
button (Fig.1-2)
Dispense 2 cups of water (approximately 150
ml each) (see chapter "Hot Water Dispensing")
from the steam wand and then another two
cups of water (approximately 150 ml. each)
from the coffee brew unit, by pressing the
coffee button (Fig.1- 1).
Turn off the machine by pressing the on / off
button (Fig.1-2).
5. Let the descaling solution take effect for
approximately 20 minutes with the machine
turned off.
6. Turn on the machine by pressing the on / off
button (Fig.1-2).
Dispense 2 cups of water (approximately
150 ml. each) from the steam wand and then
another two cups of water (approximately 150
ml. each) from the coffee brew unit.
Turn off the machine by pressing the on / off
button (Fig.1-2) and leave it off for 3 minutes..
7. Repeat the water dispensing described in step
6, until the water tank is completely empty.
8. Rinse the water tank and fill it with fresh
drinking water. Empty the drip tray.
9. Place a container under the steam wand. Open
the steam/hot water knob (Fig.1-7) slowly by
turning it counter-clockwise.
Press the brew button (Fig.1-1) and the steam
button (Fig.1-3).
10. Dispense the whole water tank content through
the steam wand. To stop dispensing, press the
brew button (Fig.1-1) and the steam button
(Fig.1-3) again and close the knob by turning
it clockwise.
11. Fill the water tank with fresh drinking water.
Insert the lter holder (Fig.1-17) into the brew
unit (Fig.1-8) from the bottom, aligning the
reference mark on the lter holder handle with
the ( ) icon on the front panel of the machine
(Fig.3). Turn the lter holder from left to right
until it locks into place on the ( ) icon (Fig.4).
12. Place a suitable container under the filter
holder.
13. Press the coffee button (Fig.1-1) and dispense
all the water in the tank. Once the tank is empty,
stop dispensing by pressing the coffee button
again (Fig.1-1) Finally, empty the container.
14. Remove the filter holder from the unit by
turning it from right to left and rinse it with
fresh drinking water.
15. Repeat the operations from step 8 once again,
for a total of 4 tanks. The machine is now ready
to be used.
16. The descaling cycle is now complete.
17. Refill the water tank with fresh water. If
necessary, load the circuit as described in the
chapter "Loading the Circuit".