Quick Installation Guide

Pub. 42004-538AQG
HUBBCOM GRC600 Remote Station Quick Installation Guide Page 2 of 5
C:\Users\PDrenning\AppData\Local\Microsoft\Windows\INetCache\Content.Outlook\PB6OVX22\HUBBCOM GRC600 Remote Station Quick Installation
Guide.docx
10/19
ATTENTION
—Utilisez uniquement des alimentations 24 Vcc conformes à UL / CSA / CE Classe II, des
alimentations à double isolation avec protection contre les surtensions et les courts-
circuits. Utilisez uniquement une source cc avec une sortie maximale de 50 watts ou
fusionnez l’alimentation avec un fusible de 2 ampères. Normes EMI à la classe B.
• Manutenzione—non tentare di riparare l'unità da soli. L'apertura o la rimozione dei coperchi potrebbero esporre
a tensioni pericolose o altri rischi. Rivolgersi a personale qualificato per l'assistenza.
• Gli HUBBCOM Smart Controller sono progettati esclusivamente per uso interno.
AVVERTIMENTO
—Utilizzare solo alimentatori a 24 V cc conformi a UL / CSA / CE Classe II,
alimentatori a doppio isolamento con protezione da sovratensione e cortocircuito.
Utilizzare solo una fonte di corrente continua con un'uscita massima di 50 watt o
collegare l'alimentazione con un fusibile da 2 A. Standard EMI per la classe B.
• Mantenimiento—no intente reparar esta unidad por sí mismo. Abrir o quitar las cubiertas puede exponerlo a un
voltaje peligroso u otros peligros. Remita todo el servicio a personal de servicio calificado.
• Los controladores inteligentes HUBBCOM están diseñados para uso en interiores solamente.
ADVERTENCIA
—Utilice solo fuentes de alimentación de 24 V cc que cumplan con UL / CSA / CE
Clase II, fuentes con doble aislamiento con sobretensión y protección contra
cortocircuitos. Utilice solo una fuente de CC con una salida máxima de 50 vatios o
fusione la fuente con un fusible de 2 amperios. Estándares EMI a Clase B.
Installation
The HUBBCOM Remote Station can be surface mounted on a wall or flush mounted using a (customer provided)
two-gang electrical box.
Safety Hardware
The HUBBCOM Remote Station described in this manual is vandal resistant. The front cover is attached to the
mounting plate with security screws. A Torx T-10 security screwdriver is required to install the station.
Surface-mount
1. Remove the two security screws from the bottom of the station.
2. Drill two holes through the mounting plate at the drill points and corresponding holes in the mounting surface.
3. Secure the mounting plate to the wall using ? (customer supplied).
4. Feed the Ethernet cable and all additional cables through the hole in the mounting plate.
5. Complete all necessary cable terminations (see the Wiring section).
6. Assemble the front cover to the mounting plate and secure it with the two security screws removed from the
bottom of the station in Step 1.
7. Tighten the screws to 3–5 in∙lb.
Flush-mount
NOTE: A customer supplied two-gang electrical box is required to flush-mount the HUBBCOM Remote Station.
1. Install the two-gang electrical box in the mounting surface.
2. Remove the two security screws from the bottom of the station.
3. Feed the Ethernet cable and all additional cables into the electrical box and through mounting plate.
4. Assemble the mounting plate to the electrical box using #6-32 x ½-inch flat head screws (customer supplied).
5. Complete all necessary cable terminations (see the Wiring section).