User's Manual

GS2011MIPS
This document describes a simple method for characterizing GS2011MIPS WLAN module based
RF parameters, such as transmitted spectra and receiver sensitivity. It will be described step by step
below that how to control and setup.
Step 1 : Extract to CDM20814_WHQL_Certified.zip, it is a USB to UART driver, then setup it.
Step 2 : Setup teraterm_utf8-4.58.exe program, this program can help to send command to module.
Step 3 : Double click UTF-8 execute file as shown below, it will occur after completing step2 install.
Figure 1
Step 4 : When implement UTF-8, selecting Serial port correctly.
Figure 2
Step 5 : After entering UTF-8, send command at. If connection is successful, it will reply ok.
User Manual Sheet of 18 July. 03, 2014
Proprietary Information and Specifications are Subject to Change
2