User's Guide

15
1.6 Cu. Ft. Over-the-Range Microwave
www.insigniaproducts.com
5 Carefully push the louver back into place and replace the louver mounting screws.
Louver
Changing the light bulbs
Countertop light (exterior)
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the screw holding the light cover in place, then remove the light cover.
•
CAUTION
The light cover may become very hot. Do not touch the glass when the light is on.
3 Remov
e the old light bulb, then replace with a new bulb.
•
CAUTION
Do not use a bulb larger than 30 watts.
4 R
eplace the light cover and secure it with the screw.
Light cover
Light bulbs
Screw
BOTTOM
Microwave light (interior)
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end
of the louver to disengage it.
Louver mounting screws
NS-OTR16SS9 REV B_20-0410_MAN_V1_EN.fm Page 15 Thursday, December 10, 2020 9:36 AM