Installation Instructions

microwave oven.

12. Do not cover or block any openings on the appliance.

13. Do not store or use this appliance outdoors. Do not use this product near water, for

example, near a kitchen sink, in a wet basement, near a swimming pool, or similar

locations.

14. Do not operate this appliance if it has a damaged cord or a plug, if it is not working

properly or if it has been damaged or dropped.

15. Do not immerse cord or plug in water. Keep cord away from heated surface. Do not let

cord hang over edge of table or counter.

16. This appliance should be serviced only by qualified service personnel, contact nearest

authorized service facility for examination, repair, or adjustment.

17. When cleaning surfaces of door and oven that comes together on closing the door, use

only mild, nonabrasive soaps, or detergents applied with a sponge or soft cloth.

18. This equipment has been tested and found to comply with Part 18 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the product.

19. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

SAVE THESE INSTRUCTIONS