Installation Guide

Thank you for purchasing a G alanz produc t. P lease read this manual c arefully for correct us age and safety,

and keep for future reference. For service, support and warranty information, call 800- 562- 0738.

FPO

INSTALLATION INSTRUCTIONS

GAS PRESSURE REGULATOR

The gas pressure regulator supplied with this range must be used.

The inlet pressure to the regulator should be as follows for proper

operation:

GAS SUPPLY PRESSURE TESTING

Gas supply pressure for testing regulator must be at least 1" Water

Column Pressur (WCP) above the manifold pressure shown on the

model/serial rating plate.

If local codes permit, a new CSA design-certiﬁed, 4 - 5 ft (122 -

152.4 cm) long, ½" (1.3 cm) or ¾" (1.9 cm) I.D., ﬂexible metal

appliance connector may be used for connecting range to the gas

supply line.

A ½" (1.3 cm) male pipe thread is needed for connection to the

female pipe threads of the inlet to the appliance pressure regulator.

Do not kink or damage the ﬂexible metal tubing when moving the

range.

The rigid pipe connection requires a combination of pipe ﬁttings to

obtain an in-line connection to the range. The rigid pipe must be level

with the range connection. All strains must be removed from the

supply and fuel lines so range will be level and in line.

Flexible metal appliance connector:

Rigid pipe connection:

Minimum pressure: 5" Water Column Pressure (WCP)

Maximum pressure: 10.5" WCP

Natural gas:

Minimum pressure: 8" WCP

Maximum pressure: 13" WCP

Contact local gas supplier if you are not sure about the inlet pressure.

LP gas:

Input ratings shown on the model/serial rating plate are for elevations

up to 2,000 ft (609.6 m).

For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate

of 4% for each 1,000 ft (304.8 m) above sea level (not applicable for

Canada).

Burner Input Requirements

The range and its individual shutoff valve must be disconnected from

the gas supply piping system during any pressure testing of that

system at test pressures in excess of 0.5 psi (3.5 kPa).

Line pressure testing above 0.5 psi gauge (14" WCP)